Contact Our Licensed Connecticut Plumbers for Your Faucet Repair and Fixture Replacement
Affordable And Quality Faucet Repair From Local Connecticut PlumbersFixing a leaky faucet can be very stressful. Droplets of water can start small, but if you won’t pay attention, you might end up losing more money and causing more harm. Let’s get down to the nitty gritty, shall we?
What are the usual signs of this issue?
- Water damage or wet spots like floors or walls
- Spitting faucet
- Sounds coming from the fixture
- Mineral deposits
- Handles that are squeaky
- Low water pressure
- Increased water bill
- Leaking sounds
What are the common causes of these problems?
- When mineral deposits build up on internal parts
- The valve seals may be corroded
- Pipes may be cracked or broken
- Fixtures are improperly installed
- Worn-out gaskets
- Faulty washers and O-rings
- Sediment corrosion
- Loose parts
- Water pressure
- Worn-out cartridge
Here’s what you’re up against if you leave that drip unattended:Expensive Water Bills Did you know that fixing one faucet can save you as much as ten percent from your yearly water bill? Sum that up and you’ll know were talking about a huge chunk of cash. Damage to Your Home and Property Leaving your sink unchecked can add stress to your pipes, which can cause clogs and overflows. This can also deteriorate your caulk and your grout, which could then cause water to seep through your floorboards and ceilings, causing more damage. Bad for the Environment If for you, the 10% you could save from your yearly water bill doesn’t count, how about more than 10,000 gallons of water? Yes, that’s how much is wasted an annually from an average household leak. Imagine how much water you’re actually throwing away – literally down the drain?
Easy Faucet Cleaning Tips from Our Plumbing Experts in ConnecticutIf ever you would rather do things your own, here are a few tips we’ve gathered from our professional CT plumbers. These may come in handy, so make sure to keep a list or take notes. Before you start, examine the faucet closely to determine the source of the leak. Locate the water shutoff valve, usually below the sink. If you can’t find it or if the valve is broken, turn off the main water valve instead. Before dismantling anything, make sure you cover the sink’s drain with a piece of cloth or a strainer to make sure no loose parts go down the drain – literally. Now for the hard part… This is the time you need your photographic memory to remember which parts go where as you remove them. Handy tip: Video yourself with your cellphone camera to know how you removed the parts and how to put them back afterwards. Once everything is removed, take a look and check the inner part for any mineral deposits or worn-out gaskets. Clean the surface by using cloth and use vinegar to loosen up any mineral deposits. There may be plugged holes within the faucet, so loosen them with a screwdriver. Before replacing parts that are broken, put a piece of cloth over the faucet and slightly turn on the shut off valve to remove any small particles that may have been stuck or loosened. Reassemble the faucet and gradually turn on the shutoff valves. Let the water run until the pipes run out of air. Don’t forget to remove the aerator and clean it as well.
Repair or Replace?For an ordinary faucet, it’s usually more practical to just buy a new fixture. However, if you’re using a high-end Kohler or Hansgrohe sink faucet, then you may need to repair it instead.
Choosing the Best Faucet for Your HomePlumbing fixtures, specifically faucets, come in a number of styles and fit a variety of functionality preferences. There are many options to consider, and these will depend on your style and preferences. But the best fixtures have four things in common: